ZBoost PRO Spécifications télécharger pdf (Page 12)

zBoost

PRO 3500 ZBC3500 Manual

Grounding the External Antenna

If you decide to place the External Antenna outdoors, it must be properly grounded. (See page iv for

a recommended grounding kit).

The set up must be in accordance with Article 810 of the National Electric Code (NEC). A listed

antenna discharge unit must be provided for the lead-in coaxial cable per NEC article 8.10.20 or

the shield of the coaxial cable must be permanently and effectively grounded in accordance with

NEC article 8.10.21. Please consult a professional installer or electrician for more information. (See

page v).

Securing Cable with a Drip Loop

If you place the External Antenna outdoors, create a drip loop

with the coaxial cable at the point where the cable enters the

home through an outside wall. This can be done by twisting and

securing the cable into a loop (no less than 4” across) near the

entry point. This will help prevent moisture from gathering at entry

point and leaking into the home. Consult a professional installer if

you need more information.

Power Requirements

The Base Unit can be plugged into a standard 2 or 3 prong 110 VAC receptacle using the Included

power supply. The power supply consumes less than 10W (less than 0.2A).

Warning

The zBoost ZBC3500 PRO 3500 base unit MUST only

be used with the provided power adaptor. Use of other

power adaptors will void the warranty and may damage

the unit. Use of other equipment is not FCC approved.

Coax Cable

Exterior Wall

Note

Avoid placing the External Antenna near metal such as

wiring, A/C ducts, metal siding, truss plates, etc.

When connecting the cable to the antenna, run the

cable straight down from the antenna. Avoid draping

the coax near the antenna.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Pas de commentaire

ZBoost PRO Spécifications Page 12