ZBoost PRO Spécifications télécharger pdf (Page 14)

zBoost

PRO 3500 ZBC3500 Manual

NOTE: The zBoost ZBC3500 PRO 3500

requires at least 15 feet of vertical separation

between the Base Unit and the External

Antenna. Generally, increasing this distance

(up to 40 feet) will increase the performance

and decreasing the distance will limit zBoost

performance.

THIRD: Run the Coaxial Cable

NOTE: Refrain from securing cable or drilling

holes until the system has been tested.

Connect the supplied 30 feet of RG-6 coaxial

cable to the base of the External Antenna.

Run the coaxial cable along a descending

pipe or through a wall that leads closest to the

location of the Base Unit. Should you need

additional cable length, 15 foot extensions (Part

#: YX030-15w) are available at www.zBoost.com. Please note: Cable longer than 65 feet is not

recommended.

FOURTH: Connect zBoost Base Unit to Power

Connect the zBoost Base Unit to the power supply and plug into a power outlet.

Upon initial power up, the LED will cycle RED, GREEN and ORANGE for 30 seconds. After 30

seconds, a series of GREEN ashes will indicate the quality of your setup. Following this, a solid

GREEN light indicates normal conditions. If it is not solid GREEN, follow the instructions in the

Base Unit LED Indicators section. Adjustments may be needed to optimize performance. If you nd

the increased signal coverage is acceptable, however, no additional adjustments are needed. See

“zBoost Base Unit Light Indicators” on page 10) for more information.

zBoost Base Unit

Power Supply

Indoor Antenna

Coaxial Cable

Wall Mounting

Bracket

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

ZBoost PRO Spécifications Page 14